This driver was installed by many users and received an average rating of 3.8 stars out of 52947 votes. Restart your computer and enjoy the new driver, it is as simple as that.The driver setup wizard will analyze your PC for compatible devices and will install the driver.

Follow the driver setup wizard, which should be pretty easy to follow.

If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.

Run the driver setup file from a Windows account with the highest privileges (rights).

This download link is for the driver version 2.04.06 released on.

Download the setup file for FTDI Hondata S300 ECU driver from the location below.

Manually install FTDI Hondata S300 ECU driver

Hondata S300 ECU is a USB Universal Serial Bus device. The developer of this driver was FTDI. The hardware id of this driver is USB/VID_0403&PID_F5FA.ġ.

Currently this is only supported by the s300 & KPro as almost all FlashPro ECUs do not have accessible outputs.FTDI Hondata S300 ECU how to download and install the driver It also is possible to use two independent fuel systems for each set of injectors (eg the secondary injectors may use E85 or race gas). eg stock 310cc injectors can be used until boost, at which point both 310cc and 1300cc injectors are used. The injector sizes and dead times for each set of injectors do not need to be the same. The secondary injectors activate based on driving conditions, and may be larger than the primary injectors. The primary injectors are always used, and may be stock or other injectors with a rapid opening time and good spray pattern. Staged injection allows the use of primary and secondary injectors of different sizes. Activation input allows easy injector staging. Street Sweeper Header -Tanabe Ultra Medallion exahust -Crower Stage 2 Cams -Hondata S300 F FuLLThRoTTLeGsR Registered.Housing sealed to IP65 (water resistant).Injector current control to ensure both rapid injector operation and low injector temperature.Drives both peak and hold (low impedance) and saturated (high impedance) injectors.Four channel injector driver with activation input.The Hondata injector driver box allows the use of high or low impedance injectors without a resistor box either as injectors slaved to the ECU injector output or as staged injectors.

Hondata s300 driver